DISCLAIMER: These steps are for informational purposes only. If you break your device, I’m not responsible. In the install, a part in the Microvision is getting modified. If you don’t agree, hit the back button. Thanks, The Management! 😎👍
Always practice safe static protection. There are lots of pics and tips for installing the new Backlit LCD Kit. Click on any pic and at the bottom you will see a link for full size to get even more detail. Then magnify to full size. The pics and tips page scrolls well with a phone or any device in wide mode. Most will find this to be a bit overkill but hopefully should answer any questions visually that may come up. A picture is always worth a thousand words.
‼WARNING: PLASTIC SCREW HOLE STATIC CHARGED FLAKES MAY CAUSE MADNESS‼
Use something similar to a makeup powder brush works.
SUGGESTED TOOLS: THIN LEAD MECHANICAL PENCIL or THIN SHARPIE MARKER, XACTO KNIFE, 3″ PIECE OF 2″ PAINTERS TAPE, SOLDERING IRON AND FLUX, FLUX BRUSH FOR CLEANING, ISOPROPANOL(RUBBING ALCOHOL),
Hi friend. Sorry for the inconvenience. I am thinking of buying a new lcd for my microvision. The problem is the photo. All pixels light up but the game is heard. Could you tell me if I have to change the LCD or is it due to another problem such as LCD voltage regulation or brightness adjustment? Thanks a lot.
Hello. I see all of the blocks are on. Does the contrast adjustment on the back of the device have any effect?
If it has an effect but all the blocks come out lit to a lesser or greater extent, but neither the marker nor the game comes out. I have also disassembled and cleaned lcd contacts with the plate and other connections between the game and the console without result.
I would send in your MV for the install.
Already tried turning the contrast. I have also disassembled and cleaned lcd contacts with the plate and other connections between the game and the console without result.
Are you planning to send in your MV for the install?
Nice instructions. 👍😎
Why thanks!